Air Filter Element Oil Filter Set

🔧 Genuine Quality Assurance: All components are manufactured strictly according to CFMoto OEM technical standards. The air filter's efficiency and dust-holding capacity, and the oil filter's filtration precision and bypass valve pressure are identical to the original parts, ensuring optimal engine protection.

🔧 Preparation

• Ensure the engine is turned off and cooled to room temperature (to avoid burns).
• Prepare tools: oil filter wrench (or strap wrench), socket wrench, drain pan, funnel, new engine oil, and clean rags.
• Place the vehicle on level ground and engage the parking brake.
• Wear protective gloves to avoid contact with hot oil and chemicals.

🛢️ Step 1: Replace the Oil Filter

• Locate the oil filter cap (usually on the side of the engine) and remove the cover bolts using a socket wrench.
• Carefully remove the old oil filter (0800-011300-0004), noting that residual oil may spill out.
• Clean the filter mounting surface to ensure no old gasket material or debris remains.
• Remove the old O-ring (0800-014003) and clean the sealing groove.
• Apply a small amount of clean engine oil to the new O-ring and install it into the sealing groove.
• Install the new oil filter (0800-011300-0004) into the mounting base, ensuring it is properly seated.
• Install the filter cap and tighten the bolts to the specified torque (do not overtighten).

🌬️ Step 2: Replace the Air Filter

• Locate the air filter box (usually under the seat or at the front of the vehicle).
• Release the clips or remove the screws securing the air box cover, and carefully open it.
• Remove the old air filter element (0GSV-112000-3000), noting its installation orientation.
• Clean the inside of the air box using a damp cloth or vacuum to remove dust and debris.
• Remove the new air filter element from its packaging and check for any damage or deformation.
• Following the same orientation as the old filter, place the new filter into the air box.
• Ensure the filter sits flush with the box edges, with no gaps or twisting.
• Close the air box cover and secure the clips or screws, ensuring a tight seal.

✅ Step 3: Add New Oil and Test

• Locate the oil drain plug at the bottom of the engine and place the drain pan underneath.
• Remove the drain plug and allow the old oil to fully drain into the pan.
• Clean the drain plug and sealing washer, then reinstall and tighten to the specified torque.
• Using a funnel, pour the recommended amount and grade of new oil into the oil fill port (refer to the owner's manual).
• Start the engine and let it idle for approximately 1–2 minutes, checking that the oil pressure warning light turns off.
• Turn off the engine and wait a few minutes for the oil to settle back into the oil pan.
• Check the oil dipstick to ensure the oil level is between the minimum and maximum marks, adding oil if necessary.
• Inspect the filter and drain plug for any signs of leakage.

💡 Maintenance Tips

• It is recommended to replace the oil and oil filter according to the maintenance schedule in the owner's manual (typically every 3,000–5,000 km or every 6 months).
• In dusty environments, shorten the inspection and replacement interval for the air filter.
• Do not use compressed air to blow out the air filter element, as this may damage the filter media and reduce filtration efficiency.
• The air filter element is a disposable part and is not washable or reusable.
• Always replace the O-ring when changing the oil filter to ensure proper sealing.